Warning: This product can expose you to chemicals including ethyl benzene and carbon black, which are known to the State of California to cause cancer, and toluene, which is known to the State of California to cause with defects or other reproductive harm. For more information, go to www.P65warnings.ca.gov.,First Aid: If Eye Contact: Flash with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. Remove contact lenses, if present and easy to do. If irritation persists get medical attention immediately. If Skin Contact: Wash with soap and water. If irritation persists seek medical attention. Excessive Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration. If Ingested: Do not induce vomiting. Seek medical attention immediately.,Danger: Extremely. Harmful or or fatal if swallowed. Vapor harmful. May cause eye, skin, and respiratory tract irritation. Contents under pressure. See other cautions on back panel. Keep out of the reach of children. Danger: Contains toluene (108-88-3), odorless mineral spirits (64742-48-9), aliphatic petroleum solvent (64742-89-8), calcium carbonate (1317-65-3), carbon black (1333-86-4) and liquefied petroleum gas (68476-86-8). Use only in a well ventilated area. When using inside, prevent vapor build up by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. Do not shake. When covering large areas indoors eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. Intentional misuse by concentrating and inhaling the product can be harmful or fatal. Avoid contact with eyes or prolonged contact with skin. Do not puncture or incinerate container. Do not expose to heat or store at temperature above 120 degrees F.

Directions: So easy to use! Read entire can. Wear face and eye protection, protective gloves and clothing; Make sure the area is clean, dry and free of grease, oil & dirt; Shake well: Spray 8 inches to 12 inches from surface; Apply several coats until all cracks and holes have been filled. Allow 24 to 48 hours. Hint: make sure flex seal has filled all cracks and holes and is fully cured before testing product. If light passes through apply additional coats. Use only in a well ventilated area. When using inside, prevent vapor build up by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. Do not smoke. When covering large areas indoors, eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. When applying to large areas indoors, do not exceed use of ½ of a can before allowing one hour for the coating to dry and vapors to dissipate before using again works best at can temperatures above 60 degrees F. Shake throughout application. Note: After each use, invert can and apply a short burst to clear nozzle. Not intended for use by professional roofers. This product has not been tested for use in potable water systems. May not be compatible with all plastics, vinyls & rubbers.

Swift Response